Modify GCode to restart 3D Print: Difference between revisions
Jump to navigation
Jump to search
(Created page with "* load GCode in text editor * Find lines like Z0.?: ;LAYER:0 M107 G0 F8400 X9.53 Y-66.192 Z0.4 The first line is the initial layer height l = l1 and starts the full print...") |
No edit summary |
||
| Line 1: | Line 1: | ||
* load GCode in text editor | * load GCode in text editor | ||
* Find lines like Z0. | * Find lines like Z0.*: | ||
;LAYER:0 | ;LAYER:0 | ||
Revision as of 16:43, 21 December 2020
- load GCode in text editor
- Find lines like Z0.*:
;LAYER:0 M107 G0 F8400 X9.53 Y-66.192 Z0.4
The first line is the initial layer height l = l1 and starts the full print
- now search for the line with Z=*.* where *.* is closest to the already printed height
Note down the extruder relative position E*.* before that line. Should look like this one (if measured height is 30.4 mm):
G1 F1500 E440.37857 G0 F600 X44.668 Y-41.761 Z30.4
Replace all lines between the first Z0.* line up to before the one with the current print height with the extruder initialization command "G92 E*.*." Use the noted value:
G92 E440.37857
Save and start print with that gcode...