ESP32 Remote Debugging

ESP32 Remote Debugging

Hardware

• ESP32 (no USB2Serial adapter or separate power supply needed)
• ESP-Prog Adapter 12,80 | ESP-Prog JTAG Debug & Program Downloader (12,80€ + 3,24€ shipping) https://s.click.aliexpress.com/e/BejpuNBE
• Dupont cables Female-(whatever you ESP32 needs) or similar (5-10)
  • 1 for ground
  • 4 for JTAG (TDI, TDO, TCK and TMS)
  • 1 optional for Power if ESP32 should be powered via the ESP-Prog
  • 1 optional for serial RX if you want to receive boot messages from the ESP32 via the ESP-Prog
  • 1 optional for serial TX if you want to send data to the ESP32 via the ESP-Prog
  • 2 optional for Reset and IO0 if you want to automatically control boot mode for flashing
• USB cable (ESP-Prog micro port to whatever fits into your computer)

Software

Minimalist

I did not test this

• openOCD (maybe special Espressif version)
• gdb from Tensilica toolchain

IDE

• VS Code
• PlatformIO for VS Code

PlatformIO Project Config

add this to your platformio.ini:

debug_tool = esp-prog
debug_init_break = tbreak setup

monitor_port = {yourProgPortName}
monitor_speed = 115200

;left here for experiments...
;upload_port = {yourProgPortName}
;upload_protocol = esp-prog

{yourProgPortName} could be /dev/ttyUSB2 or COM5 or similar (the lower of the 2 ports Esp-Prog exposes)

Quirks

• On Windows you need some USB driver assignment tool and drivers (not tested)
• Newer linux distros might not preinstall the old libcurses5 library. I had to install it:

sudo zypper install libncurses5

• Remember: pin RX goes to TX and TX to RX crossed, but TDI and TDO are not crossed like the other pins

Recommended

If you want Linux to assign fixed port names for your adapter, create a file /etc/udev/rules.d/98-Dual-RS232-HS.rules

SUBSYSTEMS=="usb", ATTRS{interface}=="Dual RS232-HS", KERNELS=="*:1.0", MODE:="0660", GROUP:="dialout", SYMLINK+="ttyUSB_jtag"
SUBSYSTEMS=="usb", ATTRS{interface}=="Dual RS232-HS", KERNELS=="*:1.1", MODE:="0660", GROUP:="dialout", SYMLINK+="ttyUSB_prog"

Then execute

sudo udevadm control --reload-rules
sudo udevadm trigger

You will see /dev/ttyUSB_prog and /dev/ttyUSB_jtag devices with full access for group dialout now. The *_jtag device is not really needed, because the driver finds it anyways (at least if you only have one attached at a time, like me).

Go!

• Attach your ESP32 to ESP-Prog and that via USB to your computer.
• Open your project in VS Code and press Ctr-Shift-D.

Project should build, upload, start and break at the setup() routine.